Clean Faucet Aerator Improves Water Pressure
Water pressure that is inadequate in your faucets, shower heads and sprayers might not always be a piping problem. The source of the problem is often sediment that is clogging the tiny holes in flow restrictions that can be found in the tips of fixtures, such as a faucet aerator and showerhead. This common type of problem happens due to poor water treatment in your city’s reservoirs. The water that goes through your home’s fixtures has a lot of hardness and, overtime causes buildup in pipes and fixtures’ heads. Lack of water pressure could also lead to more serious problems and, consequently, it can result into more expensive and complicated repairs. Water pressure could also be affected if your home’s piping is leaking, or if your water system has defective components like a pressure tank that will no longer hold pressure. In this particular case the easiest and most economical solution is to install a water pressure booster system.
Water Pressure Booster:
This self-monitoring system kicks on when you turn a faucet on and stays on until you turn the faucet off, ensuring a constant, steady stream of water free from pressure and temperature fluctuations.
This "no cycling" system is not only effective in increasing your low water pressure, it is also energy-efficient and thus a viable, economical solution for home water pressure problems. Homes at the end of municipal systems, homes with old pipes and homes with multi-stories that experience low water pressure problems should consider installing a water pressure booster system. The cost for an average water booster system is around $900.00 dollars. But let’s say that you have great water pressure coming through most of your fixtures and just a few have low water pressure, what can be done in this case? In this case, the lack of water pressure might be an isolated problem, which brings us to the original topic of this article.
How To Unclog Faucet Aerator?
Before jumping into fixing the problem, you must have the following tools and materials:
The Required Tools:A pair of pliers, small wire brush, toothbrush, paperclip and, small bowl.The Required Materials:Masking tape, white vinegar solution and/or lime-dissolving solution. P.s.: when pulling parts apart make sure that you keep them organized and in order. Step 1Removing The Aerator:- Use a pair of pliers to unscrew the aerator from the faucet spout.- Do not put too much pressure to the pliers when removing the faucet aerator. Step 2:Disassembling The Aerator:- Remove the internal parts of faucet aerator by pushing them out with your fingers.- If the components are stuck, pre-soak the aerator in a vinegar solution. - Use a pick or tweezers, but be careful not to damage any of the parts. - Once they’re removed, lay out the parts and inspect them for damage. - Damage components needs to be replaced. - Soak reusable parts in a vinegar solution overnight to loosen mineral deposits. Step 3:Cleaning The Aerator Parts:- Remove parts from the vinegar solution and wipe them dry with a rag.- Use a small wire brush to remove mineral deposits. - Inspect all parts for damage after cleaning. - Purchase a replacement kit or a new aerator if parts are damaged or if you are unable to clean any of the parts. - Reassemble the aerator and screw it back in the spout hand-tight. - Turn on the water and check for leaks. Tighten if necessary.
Home Fixing Drains DIY Plumbing |
